Troubleshooting - Windsor Dominator 10070090 Operating Instructions Manual

PROBLEM.
No power to machine.
Electrical shock.
Vac motor speed varies
or doesn't run.
Loss of vacuum.
Solution hose fitting
hard to connect.
Carpet not getting
clean.
Carpet too wet.
Carpet browning.
Solution not flowing
properly.
CAUSE
Faulty power cord.
Dead electrical circuit.
Equipment not grounding.
Receptacle not grounded.
Internal wiring problem.
Worn motor brushes.
Motor worn out.
Faulty switch.
Loose vacuum dome.
Crack in dome or poor
joint.
Lint or dirt clogging
vacuum screen.
Loose cuffs on vacuum
hose.
Vac motor seals leaking.
Floor tool vac chamber
clogged.
Vac motor, hose or gasket.
Corrosion on fittings.
Severe soil conditions.
Over saturation.
Leaving carpet too wet.
Too much chemical in.
Light carpet with no brown
prevention.
Solution hose connection.
Faulty pump.
Faulty floor tool valve.
Faulty pump switch.
D100 86038260 05/21/07
SOLUTION
Replace.
Check building circuit breaker or fuse box.
Follow grounding instructions exactly.
Contact an electrician to check building's wiring.
Have a trained service technician check machine's
wiring.
Replace.
Replace.
Replace.
Center and seal dome over tank.
Replace or repair using acrylic plastic cement only.
With power off, clean screen.
Tighten cuffs turning counterclockwise.
Replace.
Wash out with hose. Pick lint out with a wire.
Replace.
Clean with steel wool. Soak in acetic acid (white
vinegar). Lubricate lightly with silicone base
lubricant.
Make several passes at right angles to each other.
Use a prespray.
Adjust solution pressure to lower settings. Make
several passes with spray.
Check for loss of vac pressure.
Check label for correct solution concentration.
Go over carpet with browning prevent only.
Check for positive connection.
Repair or replace.
Repair or replace.
Repair.

TROUBLESHOOTING

4-4