Cutting Grooves; Length Stop (Model 4410 Only); Rough Cut Groove; Lenght Stop - Bosch 4310 Operating/Safety Instructions Manual

BM 2610012089 03-10 E:BM 2610012089 03-10 E 3/30/10 7:42 AM Page 30
• The depth stop adjustment is a feature used when
cutting grooves in the workpiece.
• The depth adjustment is used to limit blade depth
to cut grooves.
• A groove should be cut as a slide cut.
1. For major adjustments, press the depth stop
release button and slide the depth stop bolt to
the desired location (Figure 36).
2. For minor adjustments, simply rotate the depth
stop bolt to the desired location.
figure 36. Cutting Grooves
Use only one length stop. Using
length stops on both sides of blade,
could trap workpiece and could cause workpiece to
be thrown.
The unit's flip up length stop can be used when
making repetitive cuts of the same length.
To set the stop, simply unscrew the knob, flip the
stop into position and tighten the knob (Figure 38).
1. To set the cut length, unlock the base extension
clamping lever, reposition the base extension and
length stop, and relock the levers.
2. The maximum length that can be cut using the
length stop is approximately 18".
If desired, the length stop and knob can be moved
to the left base extension. The optional MS1230
Length Stop Kit can also be installed on the left side
to provide stops on either side of the saw.
To increase the length that can be cut using the
length stop, replace the tool's base extension rods
Saw Operations

Cutting Grooves

3. The upper jam nuts can be used to set a com-
4. Cut the two outside grooves.
5. Use a wood chisel or make multiple passes by
Depth Stop
Bolt
Upper Jam
Nuts
Depth Stop
Release Button
lower
Jam Nuts

length Stop (Model 4410 only)

with the optional MS1229 Extra-Long Base Rod Kit,
which increases the maximum length that can be cut
using the length stop to approximately 25" on either
side of the blade.
monly used groove depth. To adjust, loosen the
upper jam nuts, move to desired location, and
tighten against each other.
sliding the wood over to one side to remove the
material between the
(Figure 37).
Outside Grooves
Workpiece Chisel Cut
figure 37. Rough Cut Groove
length Stop
figure 38. length Stop
outside grooves
Knob