Process Variables; Simadyn D Software - Siemens SIMADYN D Manual

Hardware
SIMATIC NET plug-in cable 727-1 for INDUSTRIAL ETHERNET l
network card SIMATIC NET CP1613
Table 3-103 Hardware prerequisites
NOTE
SIMADYN D
hardware
System:
Subrack:
Slot 1:
Slot 1.1:
Slot 2:
Slot:
Table 3-104 Hardware design for the configuring example
3.29.2

Process variables

3.29.2.1

SIMADYN D software

System- and communication configuring D7-SYS - SIMADYN D
Edition 12.2003
PC configuring station:
A CP1613 must be installed in the PC.
SIMADYN D
SR12.1
PM6
MS51
MM11
CSH11
A SIMADYN D station must be configured and parameterized and a test
chart generated using the CFC configuring tool. The hardware
configuration is described under Point 26.1 (SIMADYN D hardware
design) . We will not discuss in detail here how SIMADYN D software is
generated using the CFC. If you require further information refer to the
SIMADYN D Configuring Instructions [4].
The CFC chart for the WinCC link does not have to be realized on a
separate chart, but is however recommended as this is more transparent.
The following function blocks are required for the coupling between
SIMADYN D and WinCC for process variables:
• LI - LAN interface block
• VM visualization block
• VI interface block
Communications configuring
12 slots with fan
CPU (with local service interface)
4 Mbyte Flash memory module
Communications buffer module
SINEC H1 interface
3-307