Initializing The Op7; Reading Function Block Connections (I/O) - Siemens SIMADYN D Manual

3.27.2.2.1

Initializing the OP7

Brief description
Configured
software
CFC chart
3.27.2.2.2

Reading function block connections (I/O)

Brief description
NOTE
System- and communication configuring D7-SYS - SIMADYN D
Edition 12.2003
• Only the relevant connections are listed in the following configuring
tables.
The function blocks @CSMPI and S7OS are connected to the configured
coupling module (SS52-MPI on CS7) via the CTS inputs. This establishes
the connection between SIMADYN D and OP7.
FB Connection
@CSMPI CTS
S7OS CTS
US
Table 3-95 Connection assignment @CSMPI and S7OS
Fig. 3-119 Initializing the OP7 on the MPI bus
A counter was configured for this function, which continually increments
from the initial value ("0") up to a final value ("50"). It then automatically
resets itself and starts again from the beginning. Output Y (counter
status) of the CTR is interlocked with a global operand (OP connection),
whose contents are read-out at OP7.
The flag No., specified under SIMADYN D for the OP connection, must
also be assigned the configured variables under ProTool/Lite.
Communications configuring
Connection assignment (significance)
D0200C.X01
(global operand, module name)
D0200C.X01
(global operand, module name)
testop.01 (address parameter)
3-295