Eton ELITE 750 Owner's Manual page 9

ALARM BY BUZZER
Press on [AL.1 on/off] key to select "
the alarm will be on by the buzzer.
Note: In "Timer A" section:
" " Means timer is set by radio.
" " Means timer is set by buzzer.
" " Means Timer is off.
LIGHT/SNOOZE BUTTON
When the alarm is activated, press the LIGHT/SNOOZE button to
temporarily deactivate the timer for 10 minutes. You can press the
LIGHT/SNOOZE button 3 times within the alarm period, after that you
can turn off the alarm by press it again.
ALARM ACTIVATION/DEACTIVATION
For the alarm to turn on the radio, it must be activated. To activate the
alarm the ELITE 750 can be turned on or off.
To activate the alarm, look at the top of the display, to the right of
where it reads TIMER A and TIMER B. Use quick, short presses
of the AL.1 ON/OFF or AL.2 ON/OFF buttons. When the speaker
is there, it wakes you to the radio playing; when the bell is there, it
wakes you to an electronic beeper; when nothing is there, the alarm
is deactivated.
SLEEP TIMER
The sleep timer enables the ELITE 750 to play any length of time
from 1 – 120 minutes and then turn off.
16
ELITE 750
OWNER'S MANUAL
" in "Timer A" section. Now,
SLEEP TIMER continued
To turn on the sleep timer, press the SLEEP button on the upper, right
front of the radio. Notice that the number of minutes to play appears
in the display. While they appear there, press the SLEEP button over
and over and it sequences through 1 to 120 minutes. Leave it on the
minutes that you want it to play.
USING THE LIGHT BUTTON
A quick press of the LIGHT button gives about 5 seconds of illumina-
tion to the SIGNAL strength indicator and the display. A long press
lights these for as long as the radio is turned on, so be careful if you're
operating on batteries, because it will make them drain faster. If you're
AC adapter is connected, the light can be left on continuously.
EARPHONE SOCKET
The earphone socket is on the lower left front of the radio and is
labeled EAR. Plug in earphones and headphones using a 3.5 mm
(1/8 inch) stereo plug. Turn the volume down before plugging them in.
LINE-IN SOCKET
The LINE-IN socket is on the lower left front of the radio and allows
you to route the sound from another device to the ELITE 750. Use
a cord with a 3.5 mm (1/8 inch) stereo plug. This socket uses an
industry standard line level input.
LINE OUT SOCKETS
On the back of the radio are the left and right line-out sockets,
labeled LINE OUT. These sockets use an industry standard line level
output and can be routed to any industry standard line level input.
ELITE 750
OWNER'S MANUAL
17