Electrical Connections - Baxi DUO-TECMAX+ Instruction Manual For Users And Fitters

For special installations of the fumes inlet/outlet ducts, the
single splitting kit (C), supplied as an accessory, can be
used. This accessory, in fact, can be used to move the inlet
and outlet in any direction. This type of installation makes
it possible to discharge exhaust fumes both outside the
SOME OUTLET DUCT INSTALLATION EXAMPLES AND THEIR RELATIVE MAXIMUM LENGTHS ARE SHOWN IN ANNEX
AT THE END OF THIS MANUAL.
Live-Neutral polarity.
and access terminal blocks
SEE WIRING DIAGRAM IN ANNEX
(L)
(N) Neutral (light blue).
Earth
(1) (2)
Put back the jumper on terminals 1-2 of boiler terminal
block M1 if the room thermostat is not used or if the
installed.
not used.
storage boiler sensor connection.
Use the relative cable grommets at the bottom of the boiler to thread the cables through to the terminal blocks.
7651561.02 (1-03/16)
(ALTERNATIVE ACCESSORY)
, used for the electrical connections, after removing the protective cover. The 3.15 A fast-
AT THE END OF THIS MANUAL
.
external Probe connection (supplied as an accessory)
2
32