Table of Contents
Advertisement
Preface
Notes to this
manual
Validity
Training courses
Questions
ii
The PROFIBUS-DP specification and the structure of the PROFIBUS-
DP messages are defined in the European standard EN 50170:
Ø
PROFIBUS Specification
Normative Parts of PROFIBUS-FMS, -DP., -PA
According to the European Standard
EN 50170 Volume 2
Edition 1.0, May 1998
PROFIBUS Nutzerorganisation e.V.
Order-No. 0.032 or 0.042 on CD ROM
This manual provides you with the following aids to make it easier to
locate the information you are looking for:
•
At the beginning of this manual you will find a complete table of
contents plus separate lists of figures and tables contained in this
manual.
•
In the individual chapters, you will find information in the left margin
of each page which will give you an overview of the contents of that
particular paragraph.
•
Following the last chapter of this manual, you will find a glossary
containing definitions of technical terms and abbreviations used in
this manual.
•
At the end of this manual, you will find a comprehensive index for
fast access to the information you need.
This manual is valid for
•
SIPROTEC devices 7SJ61, 7SJ62, 7SJ63 and 6MD63 with
•
firmware version 4.2 or higher and
•
PROFIBUS-DP communication module version 01.00.07 or
higher,
•
SIPROTEC devices 7UM61 with
•
firmware version 4.0 or higer and
•
PROFIBUS-DP communication module version 01.03.01 or
higher.
For device parameterization DIGSI version 4.2 or higher and PROFI-
BUS-DP standard mappings 2-1 to 2-n (n = device type dependent
number of standard mappings) have to be used.
See our catalog of courses for a list of available courses or contact our
Training center in Nuremberg.
If you have questions to the SIPROTEC devices, contact your Siemens
representative.
7SJ61/62/63, 6MD63, 7UM61 PROFIBUS-DP – Communication profile
C53000-L1840-B001-02
Advertisement
Table of Contents
