Customization Of The Allocations; Figure 6-1 Digsi Configuration Matrix With Columns For System Interface Routing - Siemens SIPROTEC4 7SJ61 Manual

6.2

Customization of the allocations

Figure 6-1 DIGSI Configuration matrix with columns for system interface routing
Source system
interface
Destination
system interface
7SJ61/62/63, 6MD63, 7UM61 PROFIBUS-DP – Communication profile
C53000-L1840-B001-02
The identification whether an information is routed on system interface
(PROFIBUS-DP) is shown in the columns "Source system interface" and
"Destination system interface" in the DISGI Configuration matrix.
A cross ('X') in this column indicates the associated information as
"routed on system interface".
The SIPROTEC object can be controlled via PROFIBUS-DP.
This is possible for the following information types:
IntSP Internal single-point indication (tagging)
IntDP Internal double-point indication (tagging)
SC/DC Singel control/Double control without feedback from process
SF/DF Singel control/Double control with feedback from process
The value of the SIPROTEC object is transmitted to the PROFIBUS-DP
master.
This is possible for the following information types:
SP Single-point indication
DP Double-point indication
Out Output annunciation
IntSP Internal single-point indication (tagging)
IntDP Internal double-point indication (tagging)
MV Measured values
MVMV Power meter (metered value, source is a measured value)
PMV Pulse (metered value, source is a pulsed binary input)
PROFIBUS-DP – Parameterization in DIGSI
Source
Information type system interface
Destination
system interface
6-3