Section 9: Mower Decks - White Outdoor Z - 180, Z - 180L, Z - 200 Operator's Manual

SECTION 9: MOWER DECKS

The mower deck must be level horizontally (side-to-side and front-to-back) for even cutting.
CHECKING THE LEVEL OF THE MOWER DECK - Side to side - Front to Back
Rear Edge
B
1. Check the rear tires pressure for proper inflation and tracking.
2. Position the Z-series on a hard and level surface.
3. Place the PTO switch in the OFF position.
4. Engage the parking brake.
5. Turn the ignition switch to the OFF position and remove the key.
6. Remove spark plug wire(s) from the spark plug(s). Access spark plug from the engine compartment.
7. Raise the lift handle to the highest setting (7).
8. Position the mower blades so that they run perpendicular to the tractor.
9. Measure and record the distance from the hard, level surface to the outermost edge of the right and left blade.
(See Figure 19)
10. Position the mower blades so the ends of each blade point to the front and to the rear of the tractor.
11. Measure and record the distance to the outermost edge of the right and left blade. (See Figure 20)
Measurement
Figure 19
Figure 20
Right
Front 4.50"
Back 4.688"
31
Blade
Left
4.50"
4.688"
Front Edge
A