SECTION 4: ASSEMBLING YOUR LAWN MOWER
This guide covers two model series. Models 950 thru 959 have fixed front wheels; models 960 thru 969 have caster
front wheels. All models are six speed, self propelled mowers. Much of this owner's manual pertains to both models.
However, there are some model-specific information too. Use only the information appropriate for your mower
model.
Items Required For Assembly
•
Pair of Pliers (Not necessary, but helpful)
•
Motor Oil
•
Fresh Gasoline
This unit is shipped WITHOUT GASOLINE in the fuel tank or OIL in the engine. Be certain to service
IMPORTANT:
engine with gasoline and oil as instructed in the separate engine manual before operating your mower.
NOTE: Reference to right or left hand side of the mower is observed from the operating position.
Setting Up Your Lawn Mower
Follow steps 1 through 10 to set up your lawn mower.
Step 1.
Lift upper handle. Align it with lower
handle.
Upper Handle
Step 3.
Raise complete handle assembly until it
clicks into place. Make sure not to kink
the control cables.
Step 2.
Tighten wing nuts
Step 4.
Pinch lower handle against mounting
bracket with pliers.
Step 5.
Move hairpin clip from outer to inner hole on
handle mounting bracket.
Pinch Here
8
.
Here
Inner Hole
Hairpin Clip