Power Switch; Turning The Unit On; Stride Sensor Auto-Shutoff; Immobilization Method - Integrity X / C - Life Fitness INTEGRITY Club + Series Assembly Instructions Manual

Power Switch

Located on the front panel at the base of the treadmill, the ON/OFF switch has two positions: "l" (one) for ON and "0"
(zero) for OFF.

Turning the Unit On

To turn the treadmill on, locate the ON/OFF power switch at the front of the treadmill and turn it ON.
Stride Sensor Auto-Shutoff System
The Stride Sensor auto-shutoff system detects whether a user is on the belt/deck. If the user leaves the belt/deck
during a workout, the system is triggered and the following message is displayed, User not detected on belt -
press "OK" to continue workout. If the user presses OK during this message the workout will continue without
interruption. If the user does not press OK another message will be displayed, User not detected on belt;
RESUME WORKOUT / EXIT WORKOUT. At this point power to the belt will shut off as the treadmill enters Pause mode.
If the user presses RESUME WORKOUT during the second message the workout will be resumed. If the user does not
press RESUME WORKOUT, the treadmill will continue in Pause mode and eventually end the workout. This feature can
be disabled in the Manager's Configuration.
Immobilization Method - Integrity X / C Console
The purpose of immobilizing the treadmill is to prevent unauthorized use. The system causes immobilization of the
treadmill when a pre-defined hard key sequence has been activated.
To prevent false toggling of the Immobilized feature, this sequence must be done in a 5-10 second period.
1. Press the STOP key 3 times.
2. Press the SPEED DOWN arrow key 3 times.
Page 10 of 40