Installation Instructions; Tools And Parts; Alternate Parts - Whirlpool Washer/Dryer User Manual

Tools and Parts

Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed:
#2 Phillips and flat-blade
screwdriver
Adjustable wrench that
opens to 1" (2.5 cm) or
" open-end wrench (for
adjusting washer/dryer
feet)
¼" nut driver or socket
wrench (recommended)
Wire stripper (for U.S.
only, direct wire
installations)
Caulking gun and
compound (for installing
new exhaust vent)
Parts supplied:
Remove parts package from the washer basket. Check that all
parts were included.
A
D
A. Water inlet hoses (2)
B. Inlet hose flat washers (4)
C. Front leveling feet with nuts (2)
Parts needed:
Check local codes, electrical supply and venting, and read
"Electrical Requirements" and "Venting Requirements" before
purchasing parts.
Mobile home installations require metal exhaust system hardware
available for purchase from the dealer from whom you purchased
your washer/dryer. For further information, please reference the
"Assistance or Service" section of the Washer/Dryer User
Instructions.
2

INSTALLATION INSTRUCTIONS

Level
Wood block (for leveling)
Ruler or measuring tape
Knife
Vent clamps
Pliers
Scissors
Tin snips (for new vent
installations)
C
B
F
E
D. Shipping strap (not in parts
bag. See "Remove Shipping
Strap.")
E. Drain hose
F. Silver, double wire hose clamp

Alternate Parts

Your installation may require additional parts. For information on
ordering, please refer to the toll free phone numbers on the front
page of the Washer/Dryer User Instructions.
If You Have You Will Need to Buy
Laundry tub or Sump pump system (if not already
standpipe taller than available)
96" (2.4 m)
1" (2.5 cm) diameter 2" (5 cm) diameter to 1" (2.5 cm)
standpipe diameter standpipe adapter, Part
Number 3363920
Overhead sewer Standard 20 gal. (76 L) 34" (86.4 cm)
tall drain tub or utility sink and sump
pump (available from local plumbing
suppliers)
Floor drain Siphon break, Part Number 285320,
additional drain hose, Part Number
285702 and connector kit,
Part Number 285442
Drain hose too short Drain hose, Part Number 285664 and
connector kit, Part Number 285442
Lint clogged drain Drain protector, Part Number 367031
Water faucets 2 longer water fill hoses:
beyond reach of fill 6 ft (1.8 m) Part Number 76314,
hoses 10 ft (3.0 m) Part Number 350008