Using Rinse And Spin; What Happens In Each Cycle - Whirlpool RAM4132B Use And Care Manual

Using rinse and spin
When using extra detergent for heavily soiled
clothes, or washing special-care items, you
may want an extra rinse and spin.
1. Push Cycle Control Knob in and turn clock-
wise to one of the dots on the dial, as
illustrated.
2. Pull Cycle Control Knob out. The washer
will fill to selected load size, agitate, drain,
and spin.
What happens in each cycle
When the Cycle Control Knob is set to a
number and pulled out, the washer fills to the
selected water level with the selected water
temperature before agitation and timing start.
The washer will begin agitating immediately
after filling; agitation can occur with the washer
lid up or down. After agitation starts, the knob
turns clockwise until it points to OFF and the
cycle ends.
The washer pauses brlefly throughout
each cycle. These pauses are normal for
washer operation.
NOTE: If your washer drains into a laundry
tub, remove lint collected in the tub or strainer.
M
4
Fill
hl!kl
Wash selected time
u
-e-
Drain-No agitation
Id!3
Spin
Fill
w
Rinse
Drain-No agitation
8