Advertisement
CHASE LOCK SYNCHRONIZATION
1) Set CLOCK and EXT SYNC switches to the positions appropriate for your
environment and verify connections
2) For most applications, hold SHIFT and press MENU
screen display "23 cHaSE XX" (XX = Free or Re-Chase), press DATA, rotate DATA
DIAL, select "rEcHASE" and press SET
3) Verify that Time Code is being fed to the DA-60
master device
4) Press CHASE
Note: It is essential that the Time Code type is identical across all devices in the
system. If using WORD Clock, sampling frequencies must also match.
CHECK DA-60
MK
1) Displayed at Power On
COPY ID PROVISIONS
1) Hold SHIFT and press MENU
2) Press DATA and rotate the DATA DIAL to select one of the three available options,
then press SET to confirm the operation
Note: "id-6 00" - any number of digital copies can be made
"id-6 10" - no digital copies can be made
"id-6 11" - only one digital copy is possible, copies may not be duplicated
CROSSFADE TIME
Hold SHIFT and press MENU
1)
(XX = current value)
2) Press DATA - the current time value will blink
3) Rotate the DATA DIAL until the desired value is displayed
4) Press SET to complete this procedure
EXTERNAL TIME CODE DISPLAY
1) Press MENU
MEMO POINT CAPTURE AND AUTOLOCATE
As tape plays, press either MEMO 1 or MEMO 2
1)
2) To autolocate to either memo point, press LOC 1 or LOC 2
MEMO POINT TRIM
Press MENU
1)
the upper right of the display)
2) Press DATA- the "hour" digits of the memo address screen will blink and
successive presses of DATA enable you to cycle from "minutes" to "seconds" to
"frames" and back to "hour"
3) Using the DATA DIAL and DATA key, trim the memo address to your liking
4) Press SET to confirm the edit
II SYSTEM VERSION
or
or
or
and select " EXT TC"
or
and select either " MEMO1" or " MEMO 2" (this is visible in
or
II's Time Code IN port from the
MK
until you arrive at screen display "4 coPy"
until you arrive at screen display "9 FAdE XX"
2
until you arrive at
Advertisement
