Configuring And Testing In Max - National Instruments 5401 Getting Started Manual

7. Configuring and Testing in MAX

Complete the following steps to configure and test your device:
1. Launch MAX.
2. In the configuration pane, double click Devices and Interfaces and
expand the NI-DAQmx Devices folder.
If you are using a remote RT target, expand Remote
Note
Systems, find and expand your target, and then expand Devices and
Interfaces.
♦
NI 5401/5411/5431—Expand Traditional NI-DAQ (Legacy)
Devices.
1 All signal generators except the NI 5401/5411/5431 are listed under NI-DAQmx
Devices. The NI 5401/5411/5431 are listed under Traditional NI-DAQ (Legacy)
Devices.
2 Only NI-DAQmx devices are listed under Remote Systems»Devices and
Interfaces.
NI SIgnal Generators Getting Started Guide
1
2
12 ni.com