Figure 1. Security screw removal and cover release
2. Push the cover thumb tab to release the cover from the backplate as shown above.
3. Route the wires through the opening in the backplate as shown below. Wires should be marked
Figure 2. Wire routing, mounting, and mounting dimensions
Programmable
Dimension
Touch-screen
H
3.3 in. (85 mm)
W
5.9 in. (150 mm)
D
1.3 in. (33 mm)
M
3.3 in. (85 mm)
W
H
4. If mounting the backplate directly to a wall surface, hold the backplate against the surface and
5. Secure the backplate using appropriate fasteners (refer to the section,
BAS-SVX44A-EN
Cover thumb tab
to ensure proper connection to terminals.
D
M
Two (2) slots for standard #8-32 (M4),
2"x4" junction box mounting screws.
then level and mark the fastener locations.
p.
8.) The thermostat must be level and plumb to ensure proper air movement through the
thermostat enclosure.
Installation and Wiring
Security Screw
NOTE: If the
security screw is
installed, remove
it before
attempting to
remove the cover.
"Mounting Surfaces,"
11