Panasonic FZ-G1 Series Operating Instructions - Basic Manual page 27

n Starting Up
Cannot resume.
Other startup problems. l Start the Setup Utility (è
n Entering Password
Even after entering the
password, password in-
put screen is displayed
again.
l One of the following operations may have been carried out. Press
the power switch to turn on the computer. Data not saved will be lost.
Ÿ In sleep mode, the AC adaptor or battery pack was disconnected,
or a peripheral was connected or disconnected.
Ÿ The power switch was pressed for four seconds or longer to forc-
ibly turn off the computer.
l An error may occur when the computer automatically enters the sleep
or hibernation mode while the screensaver is active. In this case, turn
off the screensaver or change the pattern of the screensaver.
return the Setup Utility settings (excluding the passwords) to the
default values. Start the Setup Utility and make the settings again.
l Remove all peripheral devices.
l Check to see if there was a disk error.
A Remove all peripheral devices including an external display.
B
Perform either of the following procedures.
Ÿ Touch and hold
screen, and then touch [File Explorer].
Ÿ Flick from the middle of the Start screen to the top, and then
touch [This PC] under "Windows System".
Touch (Start) - [Computer].
C Touch and hold [Windows (C:)], and touch [Properties].
D Touch [Tools] -
Ÿ A standard user needs to enter an administrator password.
E Follow the on-screen instructions.
l
Connect the external keyboard and start the computer in Safe
Mode, then check the error details. When the [Panasonic] boot
screen disappears
dows Advanced Options Menu is displayed. Select the Safe Mode
and press Enter .
*1
When [Password on boot] is set to [Enabled] in the [Security] menu
of the Setup Utility, [Enter Password] appears after the [Panasonic]
boot screen disappears. As soon as you enter the password and
press Enter , press and hold F8 .
<Only if the external keyboard is connected>
l The computer may be in ten-key mode.
If the NumLk indicator
key mode, and then input.
l The computer may be in Caps Lock mode.
If the Caps Lock indicator
the Caps Lock mode, and then input.
Reference Manual "Setup Utility") to
at the bottom left corner of the Desktop
[Check] /
at startup, press and hold F8 until the Win-
*1
lights, press NumLk to disable the ten-
lights, press Caps Lock to disable
[Check Now...].
27