Panasonic FZ-G1 Series Operating Instructions - Basic Manual page 21

7
Touch [Next] and touch [YES].
Touch [Reinstall Windows] and touch [Next].
8 At the License Agreement screen, touch [Yes, I agree to the provisions
above and wish to continue!] and touch [Next].
9 Touch [Next].
If the option is displayed, select the setting and touch [Next].
l [Reinstall Windows to the whole Disk to factory default.]
Select this option when you want to install Windows to the factory default. After instal-
lation, you can create a new partition. For how to create a new partition, refer to "To
change the partition structure" (è page 10).
l [Reinstall to the OS related partitions.]
Select this option when the flash memory has already been divided into several partitions
and you want to keep the partition structure. For how to create a new partition, refer to "To
change the partition structure" (è page 10).
*1 This does not appear if Windows cannot be installed to the recovery partition and the area usable by
Windows.
10 At the confirmation message, touch [YES].
11
<For localized OS model>
Select OS (32-bit or 64-bit) and touch [OK].
<For MUI OS model>
Select language and system type (32-bit or 64-bit) and touch [OK].
At the confirmation message, touch [OK].
To cancel the recovery procedure, touch [CANCEL], and touch the
pears at the top right corner of the screen.
12 At the confirmation message, touch [YES].
Installation starts according to the instructions on the screen. (It will take approximately
20 minutes.)
l Do not interrupt installation, for example by turning off the computer or performing other
operation.
Otherwise installation may become unavailable as Windows may not start up or the
data may be corrupted.
13 When Ending process screen is displayed, touch [OK] to turn off the
computer.
14 Turn on the computer.
l If the password is requested, enter the Supervisor Password.
15 Perform the "First-time Operation" (è page 8).
NOTE
l
them correctly.
16 Start the Setup Utility and change the settings as necessary.
17 Perform Windows Update.
18 <Only for model with TPM> Clear TPM (è page 20).
The date and time, and the time zone may not be correct. Be sure to set
*1
mark that ap-
21