Level Washer - Whirlpool NTW5100TQ Installation Instructions Manual

14.
Secure drain hose
Laundry Tub Standpipe
Secure drain hose to laundry tub leg, drain standpipe or inlet
hoses for wall standpipe with beaded tie strap.

LeveL Washer

Leveling your washer properly reduces excess noise and
vibration.
15.
Prepare to install leveling feet
Prop up front of washer about 4" (102 mm) with a wood block
or similar object that will support weight of washer. Then screw
locknut onto each foot to within 1" (25 mm) of foot base.
16.
Install front leveling feet
Screw feet into threaded holes at front
corners of washer until jam nuts touch washer, but are not tight.
Wall
Tilt washer back, remove wood block. Gently lower washer to
floor and slide washer to its final location. Remove cardboard
used to protect floor. Tilt washer forward, self-adjusting rear feet
will click into place. Gently lower washer to floor.
1"
(25 mm)
Place a level on top edges of washer, checking each side
and front. Rock washer back and forth to make sure all four
feet make solid contact with floor. If not level, tip washer and
adjust feet up or down, repeating as necessary.
17.
Engage rear leveling feet
18.
Check levelness of washer
place level here
Not Level LEVEL Not Level
7