Ap1201 - Alcatel-Lucent Stellar AP Series Deployment & Configuration & Troubleshooting Manual

✓ AP upgrading through bootloader
# tftpboot 0x84000000 OAW-AP1250-UBOOT_FIRMWARE_3.0.x.x.bin
# nand erase 0x0 0x10000000 && nand write 0x84000000 0x0 $filesize &&
nand read 0x84000000 0x03000000 $filesize
# nand read 0x85000000 0x0 $filesize && md5sum 0x85000000 $filesize
# nand read 0x83000000 0x03000000 $filesize && md5sum 0x83000000
$filesize
# reset
✓ After AP reboot, entering below commands to make dual system working.
# fm switch
_
# reboot

4.4.6 AP1201

Procedure of the upgrading AP1201 Series through bootloader:
✓ To setup a TFTP server on a PC, and put the images on the TFTP server path:
 OAW-AP1201-UBOOT_FIRMWARE_3.0.x.x.bin
✓ Network configuration (IP Address, TFTP Server Address...)
Example: IP address=
# set ipaddr 172.16.18.11
# set serverip 172.16.18.129
✓ AP upgrading through bootloader
# tftpboot 0x84000000 OAW-AP1201-UBOOT_FIRMWARE_3.0.x.x.bin
Stellar AP | Deployment & Configuration & Troubleshooting Guide
P a g e
172.16.18.11
; TFTP Server Address=
172.16.18.129
38 |