Ap1230 Series - Alcatel-Lucent Stellar AP Series Deployment & Configuration & Troubleshooting Manual

# nand read 0x85000000 0x0 $filesize
# md5sum 0x85000000 $filesize
# reset
✓ After AP reboot, entering below commands to make dual system working.
# fm switch
_
# reboot

4.4.4 AP1230 Series

There're two Ethernet ports on AP1230 Series, one is Gigabit Ethernet port, another
one is 2.5 Gigabit Ethernet port. We MUST use the Gigabit Ethernet port for both
upgrading AP through bootloader and upgrading UBoot version.
Procedure of the upgrading AP1230 through bootloader:
✓ To setup a TFTP server on a PC, and put the images on the TFTP server path:
 OAW-AP1230-UBOOT_FIRMWARE_3.0.x.x.bin
✓ To enter the bootloader during AP initialization, which is described in 4.4.1.
✓ Network configuration (IP Address, TFTP Server Address...)
Example: IP address=
# set ipaddr 172.16.18.11
# set serverip 172.16.18.129
# save
✓ AP upgrading through bootloader
Stellar AP | Deployment & Configuration & Troubleshooting Guide
P a g e
172.16.18.11
; TFTP Server Address=
172.16.18.129
36 |