Roland JU-06A Operation Manual page 16

ENTERING A PATTERN WITH
AUTOMATICALLY ADVANCING STEPS
1. Hold down the SEQUENCER [EDIT] button and press the [START] button.
Step button [1] blinks, the display indicates "S 1," and the unit is in step entry mode.
2. Press the KEYBOARD [NOTE] button to make it blink.
3. Use step buttons [1]–[12] to enter the pitch.
The gate time value will be 50.
4. The step advances automatically each time you play a note. When you have entered 16 steps, entry
mode ends.
If using the K-25m enter notes using the keyboard of the K-25m instead of steps 2–3.
ENTERING/EDITING NOTES
Press the SEQUENCER [EDIT] button to make it light.
Set the [NOTE/GATE] switch to the "NOTE" position.
Hold down the step button for which you want to enter a note, and use the [VALUE] knob to select the
note number.
The display shows the note number.
You can also select a note number by holding down a step number and playing a note on the keyboard
of the K-25m.
By holding down multiple step buttons and turning the [VALUE] knob, you can enter the same note
number for all of the buttons that you're holding down.
A lit step button indicates note-on, and an unlit step button indicates note-off.
ENTERING/EDITING THE GATE TIME
1. Press the SEQUENCER [EDIT] button to make it light.
2. Set the [NOTE/GATE] switch to the "GATE" position.
3. While holding down the step button at which you want to enter a gate, use the [VALUE] knob to select
the gate time.
The display indicates the value.
By holding down multiple step buttons and turning the [VALUE] knob, you can enter the same gate time
for all of the buttons that you're holding down.