Registration Roller Assembly - Epson EPL-N2000 Service Manual

EPL-N2000 Service Manual

3.2.12 Registration Roller Assembly

1. Remove the outer covers. (Refer to Section 3.2.1.)
2. Remove the Fusing Unit. (Refer to Section 3.2.2 .)
3. Remove the Transfer Unit. (Refer to Section 3.2.6.)
4. Remove the High Voltage Supply Board. (Refer to Section 3.2.7.)
5. Remove the Paper Empty Sensor Assembly. (Refer to Section 3.2.9.)
6. Remove the Paper Takeup Roller Unit. (Refer to Section 3.2.11.)
7. Remove 2 CCS screws (3X8) securing Registration Roller Assembly.
8. Remove the Registration Roller Assembly.
Figure 3-22. Registration Roller Assembly Removal
When reinstalling the Registration Roller Assembly , fit the pins on the Registration Roller
Assembly into the corresponding holes in the Drive Unit.
Rev. A
Assembly Note
Disassembly and Assembly
3-23