Working In Moist Conditions; Working Against Prevously Worked Ground - Grizzly Field Boss Folding Wing Manual

10 Operating Instructions
IMPORTANT!
If the lead disc overlaps too little
(less than 9" [one disc]), then soil
cut-out will not be complete. If the
lead disc overlaps too much (more
than 9" [one disc]), then a line or
gutter may be left in the ploughed
ground.
IMPORTANT!
Always lift the plough out of work
when turning sharply on headlands.
Failure to lift the plough while
turning will cause uneven working
and ridging in the soil and may
also cause excessive forces and
damage to the plough. Also when
turning sharply make sure the
plough pull does not contact rear
tractor tyres, otherwise damage
may occur.
30
10:5: 7 Working in Moist
Conditions
Your Grizzly features revolutionary Floppy T
Bar Scrapers which enable it to operate in
conditions in which ploughs with conventional
scrapers would fail.
However there are limitations to the
performance of any disc plough. There are
various adjustments which can be made to
assist the performance of your plough in trying
conditions (refer Gang Angle Selection in
previous section).
There may be times when your plough will
block. In these situations, it will be necessary
to wait until conditions are more suitable.
IMPORTANT!
When working at excessive speed
in dry conditions, premature disc
wear may occur.
Specifications are subject to change without prior notification
10:5: 8 Working Against
Prevously Worked
Ground
Identify the mark left by the filler disc (outside
rear disc) from a previous round which is a
guide for placement of the leading disc (on
either side).
The lead disc should be cutting (one disc) in
from the filler disc mark.
The filler disc mark must be ploughed out by
the leading disc for cut-out to be complete.
From serial number 6714
Including 6586, 6666, 6703