Preparing The Field Boss Folding Wing For Transport; Pin The Lock-Up Bar For Transport; Fit Travel Pins For Transport - Grizzly Field Boss Folding Wing Manual

10 Operating Instructions
10:3 Preparing the Field Boss
Folding Wing for Transport.
Folding Wings for Transport
To fold the wings for transport, follow these
instructions:
1 Raise the plough off the ground with the lift
circuit.
2 Fold the wings up until they rest in the wing
cradles. Make sure every body is well clear of
the machine when folding the wings up.
3 Lock both wings into their cradles with the
pins provided.

Pin the Lock-Up Bar for Transport

The plough's lock-up bar (located under the
pitch control) must be pinned to provide a rigid
hitch for transport. This involves inserting two
pins into the transport lock-up bar. To do this:
1. Fully raise the plough on the wheel lift
circuit.
2. Using the Pitch Control cyclinder, level the
machine by eye from the tractor.
3. Remove both lower and upper pins from
lock-up slides and pin either slide, which
allows machine to be at the closest level.
4. Adjust the cylinder so that the second
slide can be fitted and pinned. Ensure the
pin is locked.
26
Wing Locking Pin
Lock Up Bar in Transport Position
Specifications are subject to change without prior notification
Travel Pin

Fit Travel Pins for Transport

Before the plough is transported, it is
essential that the travel pins are placed on the
wheel lift cylinders.
1. Fully raise the plough off the ground.
2. Next fit and secure the travel pins (stored
in the plough toolbox) to the wheel lift
cylinders.
3. When both travel pins are fitted, keep the
pressure in the lines so weight is on the
cylinders not on the travel pins.
WARNING!
Always stay out from underneath
a Field Boss Folding Wing unless it
is resting firmly on the ground or
supported with transport pins.
From serial number 6714
Including 6586, 6666, 6703