Nortel Meridian 1 Manual page 33

Telephone Positions
Your Meridian telephone can be installed in three different positions - two
desktop positions and a wall mount position. The two desktop positions
provide two different angles for the telephone on the desktop. The telephone
is supplied in the steeper of the two positions. The procedure to change to the
more shallow angle is as follows:
1 Unplug the line cord from the connecting block.
2 Remove the handset and place the telephone upside down on top of a
level, solid work surface covered with soft material or paper to prevent
damage to moveable keys and the telephone face.
3 Remove the 2 screws from the telephone footstand (if fitted) to separate
the footstand from the telephone.
4 Snap the footstand back into place using the alternate slots located closer
to the back of the set and tighten the screws (if previously fitted).
5 Place the telephone back on the desk in the normal operating position.
6 Plug the line cord connector back into the connecting block.
The procedure to wall mount the telephone by reversing the footstand is as
follows:
Note 1: The footstand cannot be reversed when the MCA data option or
key expansion module is equipped so such telephones cannot be wall
mounted.
Note 2: An additional clip is provided for wall mounting the telephone.
This clip is attached to the switchhook rest to prevent the handset from
slipping when mounted on the wall.
1 Unplug the line cord from the connecting block.
2 Remove the handset and place the telephone upside down on top of a
level, solid work surface covered with soft material or paper to prevent
damage to moveable keys and the telephone face.
3 Remove the 2 screws from the telephone footstand (if fitted) to separate
the footstand from the telephone.
Meridian digital telephones
Meridian 1 European Digital Telephones
Page 33 of 46