Nortel Meridian 1 Manual page 29

Installation
The Installation procedure for Meridian digital telephones follows:
1 Complete the wiring and cross-connections (loop power) before
connecting the telephone to the connecting block.
2 Place the telephone on the desk in the normal operating position.
3 Place the Rls and Hold key caps on their positions just above the dialpad,
with the Hold key closest to the handset.
4 Print the directory number on the designation card. Remove the number
lens from its position underneath the handset, insert the designation card
and snap the lens into place.
5 Print the feature keys on the label strip. Remove the label lens (beside the
feature keys), insert the label strip and snap the lens into place.
6 Plug the line cord connector into the connecting block.
7 Perform the self test and acceptance procedures (see procedure 16 for
Meridian Modular telephones in the Telephone and Attendant Console:
Installation (553-3001-215).
8 Supply the user with a quick reference card.
Installation of Hardware Options
This section describes the procedure for installation of the following options:
1 Power Board on all models.
2 Headset on M3310 and M3820 telephones.
3 Wallmount/Desktop Position change.
For installation of other options (MCA data option, external alerter and key
expansion modules) see the section on Add-on modules for Meridian
Modular Telephones (NT2K models) in the Telephone and Attendant
Console: Installation (553-3001-215).
Meridian digital telephones
Meridian 1 European Digital Telephones
Page 29 of 46