Nortel Meridian 1 Manual page 31

To reassemble the Telephone:
1 Replace the base cover and make sure that the cables lie flat.
2 Insert the four screws to secure the base.
3 Assemble the MCA to the footstand using the two screws provided.
4 Connect the cable to the 8 way jack on the base of the telephone.
5 Reconnect all cords to the telephone.
6 Replace the footstand with the two screws (if previously fitted).
7 Place the power board label on the footstand for tracking purposes.
Headset Installation (M3310 and M3820 only)
Use the following procedure to add a headset to a Meridian telephone:
1 Unplug the line cord from the connecting block.
2 Remove the handset and place the telephone upside down on top if a
level, solid work surface covered with soft material or paper to prevent
damage to moveable keys and the telephone face.
3 Remove the 2 screws from the telephone footstand (if fitted) to separate
the footstand from the telephone.
4 Plug the headset TELADAPT connector into the socket on the base of the
telephone marked with a headset icon.
5 Route the headset cord through the channels at the side of the telephone.
6 Replace the footstand in the same position and tighten both screws (if
previously fitted).
7 Place the telephone back on the desk in the normal operating position.
8 Plug the line cord connector back into the connecting block.
Meridian digital telephones
Meridian 1 European Digital Telephones
Page 31 of 46