Installation And Wiring - Delta DVP-MC Series Instruction Sheet

 Installation & Wiring
 Installation
Install DVP10MC11T in an enclosure with sufficient
space around it to allow heat dissipation. D >
50mm (See the figure).
 Input Point Wiring
Mode
Sink
Source
 Output Point Wiring
All transistor outputs in DVP10MC11T include zener diode, which is sufficient enough for
small-power conductive load and infrequent On/Off applications. However, in big-power
or frequent On/Off occasions, follow the method below to connect to suppression circuit
to reduce interferences and avoid the transistor output circuit from being damaged due
to over-voltage or overheating.
 24 VDC power supply
 Emergency stop button
 9V Zener diode, 5W (Use  and
 Diode or equivalent components for suppression (Use
 Connecting to DVP-S Series Extension Modules
Simplified model

 Fuse
 Load: Switch, conductive load
when in big-power and frequent On/Off occasions)

- 4 -
D
D
DVP10MC11T
D
Wiring loop
[Figure 3]
only when in small-power loads)
D