Yamaha TDM850 Owner's Manual page 90

Hide thumbs Also See for TDM850:
Table of Contents

Advertisement

EAJ630D'
7.
Remove the wheel assembly.
EVMBB01
NOTE: -
Do not depress the brake pedal when the disc
and caliper are separated.
EUU0W3XI
NOTE: _
You do not have to disassemble the chain in
order to remove or install the rear wheel.
Rear wheel installation
When installing the rear wheel, reverse the
removal procedure.
Pay attention to the following points:
1.
Make sure there is enough gap between
the brake pads before setting the caliper
or disc.
2.
Adjust the drive chain.
3.
Make
sure
the
following
parts
are
properly torqued, and a new cotter pin is
installed.
Tightening torque:
Axle nut:
110 Nm (11.0 m* kg)
Caliper bolt:
35 Nm (3.5 m • kg)
EUU647Q0
AWARNING
Always use a new cotter pin on the axle
nut.
7-45

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents