Stihl MSA 160 T Instruction Manual page 23

During Operation
The green light emitting diodes glow
continuously or flash to indicate the state
of charge.
80 - 100 %
60 - 80 %
40 - 60 %
20 - 40 %
0 - 20 %
If the light emitting diodes on the battery
flash or glow red – see "If the red light
emitting diodes glow continuously /
flash".
MSA 160 T
If the red light emitting diodes glow
continuously / flash
A
B
C
D
A 1 light emitting Battery is too
1) 2)
diode glows hot
continuously
red:
B 4 light emitting Malfunction in
diodes flash red battery
C 3 light emitting Power tool is too
diodes glow hot – allow it to
continuously cool down.
red:
D 3 light emitting Malfunction in
diodes flash red power tool
1)
When charging: Charge process
starts automatically after the battery
has cooled down / warmed up.
2)
During operation: Power tool cuts
out – allow battery to cool down; it
may be necessary to take the
battery out of the power tool for this
purpose.
3)
Electromagnetic interference or
malfunction. Take the battery out of
the power tool and refit it. Switch on
the machine – if the LEDs continue
to flash, the battery has a
malfunction and must be replaced.
4)
Electromagnetic interference or
malfunction. Take the battery out of
the machine. Use a blunt tool to
remove dirt from the contacts in the
battery compartment. Refit the
battery. Switch on the power tool –
if the light emitting diodes still flash,
the power tool is malfunctioning
and must be checked by a servicing
dealer – STIHL recommends an
authorized STIHL servicing dealer.
1)
/cold
3)
4)
English
21