Connecting 3Vf To The Communication System - Siemens 3VF Series Communications Manual

Communication System Manual

2.1.4 Connecting 3VF to the communication system

1.) Check that all the system components are fitted
Check that all the following system components are fitted before connecting 3VF to PROFIBUS-DP:
3VF circuit-breaker with internal accessories (alarm switch, auxiliary switch) and motorized
operating mechanism
Note: The motorized operating mechanism is needed for remote control of the circuit-breaker. If this
is not fitted, the circuit-breaker cannot be switched ON and OFF via PROFIBUS. The measurement
and warning functions are operational, however.
Suitable SIMOCODE-DP basic unit (cf. Selection table, page 17)
Connecting cable for parameterization using a PC or notebook
Diskette with type or GSD file (supplied with SIMOCODE-DP manual)
Parameter file (included in Win-SIMOCODE-DP from 6/98)
Win-SIMOCODE-DP software or 3WX36 handheld operator panel
COM-PROFIBUS software, only required for parameterization via PROFIBUS-DP
2.) Check the system requirements
The second step involves checking the following requirements for connecting 3VF to PROFIBUS-DP:
The 3VF circuit-breaker must be installed and wired in accordance with the circuit diagram on
pages 14/15.
The PROFIBUS-DP master must be present and operational.
SIMOCODE-DP must be correctly configured and installed (cf. user guide).
3.) Connect SIMOCODE-DP to PROFIBUS-DP
The bus cable can be connected to the SIMOCODE-DP 9-pin SUB-D connector using the standard
PROFIBUS-DP connector (order no. 6ES7972-0B.10), or it can be connected directly to the screw
terminals labeled "PROFIBUS-DP".
12
© Copyright Siemens AG 1998. All rights reserved.
3VF Circuit-Breakers
Version1.0 (05/98)