Inspect and prepare pump before each use.
•
Read instructions below carefully for inspecting and preparing the pump.
•
Damaged or clogged equipment could result in leaks or uncontrolled distribution.
•
Leaks could result in injury to the operator or bystanders.
Important safety rules:
•
Power off. Make sure all power is OFF before cleaning, inspecting, or servicing the pump.
•
Guards / shields. Make sure all guards and shields are replaced after servicing the pump.
•
Replacement parts. If a part needs replacement, only use parts that meet the manufacturer's
specifications. Replacement parts that do not meet specifications may result in a safety
hazard or poor operation of the pump.
1. Ensure clean
system
2. Inspect &
repair
Operation – Preparing the Pump for Use
Ensure the pump has been thoroughly flushed, drained, and sanitized.
Inspect and test the system thoroughly with potable water:
a)
Inspect hoses/ lines for exposed mesh and holes. Replace all worn
or damaged hoses/ lines.
b)
Inspect fittings for cracks and leaks. Replace NorthStar pump if
needed.
c)
Partially fill system with potable water and turn on to test for
leaks. Repair as needed.
IMPORTANT: After any repair work has been done, ALWAYS test for
leaks with potable water one final time before using.
WARNING
11