Shutdown And Cleanup - Graco 24S134 Operation, Parts

Shutdown and Cleanup

NOTE: Keep pump and hose clean when
switching between materials. A dirty pump
can release particles of texture into the finish.
NOTICE
Before removing material hose be sure
pressure is relieved and material is not in the
hose.
To keep sprayer in good operating condition,
always clean it throughly and prepare it
properly for storage.
When you have finished spraying:
1. Drain remaining material into bucket
until most of texture material is out of
the hopper.
2. Fill material hopper with clean water.
3. Remove nozzle from gun. Trigger gun
into bucket until most of texture mix is
pumped out. Allow water to flow through
gun until gun is clean.
3A3373C
Shutdown and Cleanup
ti28086a
4. Finish cleaning all components. A soft
brush may be used to help loosen any
dried on material from surface.
NOTE: Cleaning out all air passages
and components will improve gun per-
formance and life.
5. Connect air line to gun. Open gun air
control valve, forcing air through nozzle
to clear out any remaining material.
6. Disconnect air line and material hose
from gun.
ti28089a
ti28088a
To ensure proper gun function for future use,
remove and clean needle components and
apply a few drops of light oil to:
•
air hose quick connect
•
material hose connections
•
air shutoff needle material needle
4
5
9