Install Properly; Level Refrigerator-Freezer; Remove Sales Labels; Clean It - Whirlpool ET22ZK Use & Care Manual

Install properly.. .
I, Allow % inch (1.25 cm) space on each side and at
the top of the refrigerator for ease of installation.
2. If the refrigerator is to be against a wall, you might
want to leave extra space so the door can be
opened wrder
3. The refrigerator back can be flush agarnst the wall.
Level refrigerator-freezer.. .
Levelling SK4 1
Right to Raise;
Left to Lower
I. Remove base grille [see page 7):
2. To raise front, turn each screw to the rrght.
3 To lower front, turn each screw to the left.
4
Check with level
A
Remove sales labels.. .
Remove the Consumer Buy Gurde label, tape and
any
lnslde
labels before using the refrigerator
To remove any remaining glue:
1. Rub briskly with thumb to make a ball then remove
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it.. .
Clean your refrigerator before using tt. See cleaning
instructions on page 8 and 9
Plug it in...
J-prong grounding
type wall receptacle
t
grounding plug
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain. See
individual electrical requrre-
ments and grounding instruction sheet in your Irter-
ature package.