Install Properly; Level Refrrgerator-Freezer; Remove Soles Labels; Clean It - Whirlpool ET22MT Use And Care Manual

Install properly.. .
y-=pL1,jrl
111 II- i
1 Allow % Inch (125 cm] space on each side ana tit
the top of the refrigerator for ease of ~nstallat~or,
2 If the refrigerator IS to be against a wall, VOL might
want to leave extra space so the door car- De
opened wider
3 The refrigerator back can be flush agalrst ihe
WCII
Level refrigerator-freezer.. .
Levelling SK4 (
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
any inside
iabels
before using the refrigerator.
To remove any remaining glue:
1 Rub briskly with thumb to make
a
ball then remove
OR
2 Soak area with dIshwashIng detergent solution [I
teaspoon detergent in 1 quart warm water] before
removing glue as described in step 1
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the tront.
Clean it.. .
Clean your refrigerator
before using It
See cleaning instructions
cn page 8
Plug it in...
3-prong grounding
type wall receptacle,
Use Screwdrlver
ng Plug
Right to Raise.
Left to Lower
1 Remove base grille [see page 7)
2. To raise front, turn each screw to the rlgnt.
3 To lower front, turn each screw to the left
4. Check with level
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A '15 Volt 60 tlz AC only 15 or 20 ampere fused
C:IIC properly grounaed electrical supply is re-
aclired It is recommended that a separate circuit
serving orlly this appliance be provided
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain. See lndlvldual electrical requlre-
Ir'er% and grounding InstructIon sheet lr your liter-
c:x'c- r?ackgge