Install Properly; Level Refrigerator-Freezer; Remove Sales Labels; Clean It - Whirlpool ED26SS Use & Care Manual

Install properly.. .
1. Allow '/: inch (1.25 cm] space on each side
and at top for ease of installation.
J
2 The refrigerator back can be flush against the wall
3 If the refrigerator is to be in a corner, keep 1% inches
(3.1 cm] between the wall and side of the refrigera-
tor so there is room to open the small access door
on your SERVA-DOORR refrigerator or to clear the
Ice and water dispenser.
Level refrigerator-freezer.. .
Leveling SK% Ii 1
Use Screwdriver
lght to Raise; Lef
I, Remove base grille [see page 12).
2 To raise front, turn each screw to the right.
3. To lower front, turn each screw to the left.
4.
Check with level.
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
other non-instructional inside labels. Any remaining
glue can be removed by briskly rubbing with thumb
- or-can be soaked with dishwashing detergent
solution, then rubbed with thumb.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
4
NOTE: DO NOT REMOVE The two labels
inside the Utility Compartment. They are
permanent instructions for using the
SYSTEMS SENTINEL'* II Performance Control
Package.
Clean it.. .
Clean your refrigerator before using it. See clean-
ing InstructIons on page 12
~~IJ-~RI--YI,M"dl~l~ rs,i_l.m ce I", ..%.a. ,... IhZ>_ .YI?.Y s ,-
grounding type
Power Cord
grounding plug
RECOMMENDEDGROUNDING METHOD
All5 Volt, 60 Hz., AC only,15 or 20 ampere fused and
grounded electrical supply IS required It is recom-
mended that a separate circuit serving only this
appliance be provided.
Do not use an extension cord. Use a recepta-
cle which cannot be turned off with a switch or
pull chain. See individual electrical requirements
and grounding instructlon sheet in your literature
package
When you plug in the refrigerator...
l
Symbols on the Performance Control Package will
glow.
l
You may even hear a soft beeping sound (8 beeps
every 2 minutes]. This is normal.
To stop the beeping:
l
Touch and hold the RESET/TEST Pad until you hear 2
beeps. The Control Package "TEST" Light will come
on underneath the "OK" Light.
When the refrigerator has cooled, reset the Control
Package for scanning by touching the RESET/TEST
Pad. You will hear a beep, and the "TEST" Light will go
off. This tells you the refrigerator is In its monitoring op-
eration. (See page 6 for more information on the SYS-
TEMS SENTINEL" II Performance Control Package.)