Hitachi J300 Series Instruction Manual page 70

Rr,ll
t - t -
m
Output
t€rminal
setting
ll end 12
A terminal function is allocated to each of the ouFur intelligent terminals 1l and 12. W}len using
a function other than the standard set functions or changing tie terninal order, set the funcaion for
each terminal,
Arrary of codes and intclligcnr rcrminrls
Code
Function name
c r 0
Output terminal setting l1
l l
0
c t l
Output terminal setting 12 t )
The setting method is the same
as rhat of tie inpul terminals
FITE'o F]ES]I
NOTE: The torque o1$e ovenorque signal can be sel by thc rcmolc operator. The initial
valu€s of mobring and regeneration are I 007, lorque. The ovenorque signal can be
used only under the sensorless vector control.
Setting nethod
_ fEat .
. P|es' 'l'el,:ir"c]rct dcc lbr thc rcrminal c^d. ro hr \et
. The set values ofthe terminals wbich are set ar present are displayed. Display thc scl valuc
of th€ terminal to be used from th€ funcrion list indicated below by pressing the key
and |El and rhen ore* rh" lrarr ] r"".
.
F U N C I
'
. The display is retumed lo iie code display and ihe terminal function is changed.
Inpur rcrminal funLrron lr\t
0
FAI Frequ€ncy arrival signal
RUN Signalduring running
2
OTQ O!eforquc signal (Norc)
Enkr fie ser ralue orde Emral nde
to be sed by ersrc $e keys
E
dd
E.
Precautions for terminal settins
- Same termrnah cannor be s€r berween L I iuland L I i , .
when moving a t€rminal name to another terminal, set another terminal which is not to be
u€d at the sening source before inputting th€ set value io the setting desdnation and then
select lhe terminal name which is to be set at the settins destination.
t'*frt
LFUNcI
tE;€ I
PCB terminal anay
7-30