Hitachi J300 Series Instruction Manual page 53

t I l
t t l
Contents and display
Adjusl the analog meter connected to rhe lrequency moniror
tcrminal. (lnirial sening ofthe [FM] terrninal: Analog freqLiency moniror)
When op€ration shrrs, rrT outpurbctween FM and CMI rerminals is
proponional1() the output dara. Adjust tlre melerso fiat it indicales
lie ma\rmum pornl shen lhe oulput l\ rr rhe md\imum.
l a l i v
l m c l
-
l * -
6 u 1
[!!!q]
Inirjal value Ltl^!]
NOTE l: This funcrjon is vatid only when the analog moniroris used.
(Freqency monitor, currenl noniror, torque monitor)
NOTE 2: The adjusred value when the input terminat STN (inirialization) is used is
the inilial value.
I
c M l
l '
PLC
wlen adjusting th€ ualog freler tunnemoie, Epcat 6e sme openrion.
-
Maximurn t€vel of analos mcter __
Fequency noniror: (A6:r ndimum iEqncncr snine)
cudent nonitor (2m% of invenei ared cucnl)
l
I Torquemonno. (200%ornredrorque)
. Set the motor rcceiving voUrr". *n"n ,n"
ffi
*ey is prcssed once, rhe curreni set vatue
ot the motorreceiving voltagc is displaycd-
. Set $e receiving vokagc
frorn rh€ data on the lefi.
4{ro v a"* IJIEE ETEDI Ffi5:l Em FIEZl
Iniiial vatue
E
Sclect $e item of each cxrension function. Aficr setting, $e display is retumed to the code
@Afrerdata is chansec, te sure !o press the
ffi
r."r,o.n,r" u.
Code selection
(Set !alue (orage wair shlc)
Code sclection
+ IET---]
\ r I I A
* -
rrlog
.tceiving
!.crng
Ertension
5€!ting
I
7 -13