Using Your Range; Using The Surface Burners - Whirlpool SFOlOOSR/ER Use And Care Manual

Using your range
OVEN TEMP
SURFACE
CONTOL
BURNER
\
INDICATORS
LEFT FRONT
LEFT REAR
CONTROL KNOB CONTROL KNOB
Using the Surface Burners
RIGHT FRONT
RIGHT REAR
CONTROL KNOB
CONTROL KNOB
This range is equipped with either standing pilots or electronic ignitors. Stand-
ing pilots must be lit initially with a match following the directions on page 9.
The pilot light will remain lit when the burners are turned oft. To turn a burner on
again, just push in and turn the control knob to LITE and the burner will light.
Electronic ignitors automatically light the burners each time they are used.
Surface Burner Indicators
The solid dot in the surface burner
indicator shows which surface burner
is turned on by that knob.
Control knobs must be pushed in,
then turned to LITE position. On elec-
tronic ignitor models, the clicking
sound is the ignitor sparking.
After the burner lights, turn the control
knob back to a desired setting. The
control knob can be set anywhere
between HI and OFF. Do not cook
with the control in the LITE position.
In Case of a Prolonged Power Failure
Surface burners with electronic ignitors can be manually lighted. Hold a lit
match near the burner and horn the control to the LITE position. After the burner
lights, turn the control to the desired setting. Power failures will not affect Stand-
ing Pilots.