Abs Disabling Function - Ducati Diavel Carbon Owner's Manual

ABS disabling function

This function disables or enables the ABS.
To access the function it is necessary to view the
"setting" menu page 48, using button (1, fig. 14)
"▲" or (2, fig. 14) "▼" select the "ABS" function and
press the reset button (12, fig. 12) to go to next page.
Function state is highlighted on the display (ON in
green or OFF in yellow); Use button (1, fig. 14) "▲"
or (2, fig. 14) "▼" to shift the arrow on the left onto
the new setting and confirm by pressing the reset
button (12, fig. 12) for 3 seconds.
After these 3 seconds the system checks whether
the request was actually complied with; during the
check the display will show the message "PLEASE
WAIT...".
The new condition will be displayed after check time.
Note
If the disabling request was not met, it is
recommended to repeat the procedure. If the
problem persists, contact your Ducati dealer or
Authorised Service Centre.
To exit the setting function, press the reset button
(12, fig. 12) when "EXIT" is highlighted.
100