Whirlpool SF365BEY Use And Care Manual page 25

4. If ports are clogged, clean with a
straight pin. DO NOT enlarge or distort
the ports. DO NOT use a toothpick to
clean the ports.
5. Before putting the burners back, dry
them thoroughly by setting them in a
warm oven for 30 minutes.
6. Replace
burners, making sure they are
properly seated and level.
Replace
screws.
7. Occasionally check
the burner flames
for proper size and shape as shown. A
good flame is blue in color. If flames lift
off ports, are yellow, or are noisy when
turned off, you may need to clean the
burners (see above), or call a qualified
technician for adjustment.
Ports
T-
*' I 0 0 00 on 0 .-
Y3
Typical surface burner flame
at highest setting
Cleaning chart
Use the following table to help you clean all parts of your range.
PART
Control knobs
WHAT TO USE
Sponge and warm,
soapy water
HOW TO CLEAN
l
Turn knobs to OFF and pull straight away
from control panel.
l
Wash, rinse
and
dry thoroughly. Do not
soak.
l
Do not use steel wool or abrasive
cleansers. They may damage the finish.
l
Replace knobs. Make sure all knobs point
to OFF.
Control panels
Sponge and warm,
l
Wash, rinse and dry thoroughly.
soapy water
l
Do not use steel wool or abrasive
OR
cleansers. They may damage the finish.
Paper towel and spray
glass cleaner
l
Do not spray cleaner directly on panel.
Apply cleaner to paper towel.
Exterior surfaces
Sponge and warm,
l
Wash, rinse and dry thoroughly.
(other than control soapy water
panels)
l
Use nonabrasive, plastic scrubbing pad on
heavily soiled areas.
l
Do not use abrasive or harsh cleansers.
They may damage the finish.
NOTE:
Do not allow foods containing acids
(such as vinegar, tomato or lemon juice) to
remain on
surface.
Acids may remove the
glossy finish. Also wipe up milk or egg spills
when cooktop is cool.
continued on next page
25