Planet ISW-511 Series User Manual page 26

Installation Steps
Step 1: Unpack the Industrial Fast Ethernet Switch.
Step 2: Check whether the DIN-rail is screwed on the Industrial
Fast Ethernet Switch. (Please refer to DIN-rail mounting
section for DIN-rail installation. If you want to wallmount the
Industrial Fast Ethernet Switch, then please refer to the Wall-
mount Plate Mounting section for wallmount plate installation.
Step 3: To hang the Industrial Fast Ethernet Switch on the DIN-rail
track or wall, please refer to the Mounting Installation
section.
Step 4: Power on the Industrial Fast Ethernet Switch (Please refer to
the Wiring of the Power Inputs section for power input). The
power LED on the Industrial Fast Ethernet Switch will light
up. Please refer to the LED Indicators section for LED status.
Step 5: Prepare the twisted-pair, straight-through Category 5 cable
for Ethernet connection.
Step 6: Insert one side of Category 5 cables into the Industrial Fast
Ethernet Switch Ethernet port (RJ45 port) and the other to
the network devices' Ethernet port (RJ45 port), e.g., Switch,
PC or Server. The UTP port (RJ45) LED on the Industrial Fast
Ethernet Switch will light up when the cable is connected with
the network device. Please refer to the LED Indicators section
for LED status.
Make sure the connected network devices support MDI/
MDI-X. If the network devices do not support MDI/
MDI-X, please use the crossover Category 5 cable to
Note
connect.
Step 7: Insert fiber cable from the ISW-511 / 621 series or
ISW-511T / ISW-621T series to the fiber network. TX, RX
must be paired at both ends. The optical port LED on the
Industrial Fast Ethernet Switch will light up when the cable
is connected with network device. Please refer to the LED
Indicators section for LED status.
Step 8: When all connections are set and all LEDs are lit without any
issue, the installation is complete.
26