Table of Contents
Advertisement
SERVICE PROCEDURE-2
5. To check version of Microprocessor, DSP and Video FW(Firmware)
1. Press and hold down DISPLAY button, then press ON/STANDBY button when the unit is power on.
The main microprocessor version will be displayed on Front Display for about 3 seconds.
[e.g.]
M a i n :
1 .2 2 /0 9 Z 1 1 A H
2. [TX-NR1007, NR3007, NR5007, PR-SC5507]
Press
(TONE) button while the version is displayed. Then, version of DSP FW will be displayed.
(TONE) button is pressed while a version is displayed, the next information will be displayed.
In this way, as
If
(TONE) button is pressed, the order will be reversed.
[DTR-70.1, DTR-80.1, DHC-80.1]
Press
(Tone) button while the version is displayed. Then, version of DSP FW will be displayed.
(Tone) button is pressed while a version is displayed, the next information will be displayed.
In this way, as
If
(Tone) button is pressed, the order will be reversed.
[e.g.] In case TX-NR5007
<Note> Number depends on the version.
(TONE)
(Tone)
M a i n :
1 .2 2 /0 9 Z 1 1 A H
DSP 1st/NET:
1 .1 4 /0 9 X 2 3 A H A
DS P 2 n d :
1 .0 3 /0 9 7 2 3 A H 2
DS P 3 r d :
1 .0 5 /0 9 9 1 4 A H 3
V i d e o :
1 .1 3 /0 9 Y 0 2 A R
V S P ( R e o n ) :
1 .0 3 /0 9 Z 1 1 A E O
3. Press ON/STANDBY button to power off.
(TONE)
(Tone)
Version of Main Microprocessor FW
Version of 1st DSP FW
Version of 2nd DSP FW
Version of 3rd DSP FW
Version of Video Microprocessor FW
V id e o:
1 . 1 3/ 09Y0 2AR
[TX-NR1007]
AT
[TX-NR5007, NR3007, PR-SC5507, DTR-70.1, DTR-80.1, DHC-80.1]
AR
Version of VSP(Video Signal Processor) FW
[TX-NR1007]
Torino
[TX-NR5007, NR3007, PR-SC5507, DTR-70.1, DTR-80.1, DHC-80.1]
Reon
V S P (Reon):
1 . 0 3/ 09Z 11 AEO
[TX-NR5007, NR3007, NR1007, PR-SC5507]
AEO
[DTR-70.1, DTR-80.1, DHC-80.1]
AEI
TX-NR3007
Advertisement
Table of Contents
