Trane Thermo King SPECTRUM T-90 Series Installation Manual page 51

5. Insert doubled over end of resistance wire into drain, Tee, or 90 degree connector ( ( D D e e t t a a i i l l I I V V ) ) and then into
crossover drain tube ( ( D D e e t t a a i i l l V V ) ) .
N N o o t t e e : : The use of either white or blue drain tubes is acceptable when interconnecting multiple evaporators.
6. Attach drain Tee or 90 degree connector to evaporator drain tube and push connector on firmly to engage O-ring
( ( D D e e t t a a i i l l V V I I ) ) .
IV
7. Pull resistance wire through interconnecting drain tube as far as possible and make sure it is not bunched up ( ( D D e e t t a a i i l l
V V I I I I ) ) .
8. Insert other resistance wire into other drain Tee connector and as shown ( ( D D e e t t a a i i l l V V I I I I I I ) ) .
I I m m p p o o r r t t a a n n t t : : At no time should resistance wires from one side of the drain pan overlap the resistance wires from the
other side.
9. Attach interconnecting drain tube to opposite Tee connector by pushing Tee connector on firmly to engage O-ring
( ( D D e e t t a a i i l l I I X X ) ) .
VII
TK 56701-1-IM-EN
E E v v a a p p o o r r a a t t o o r r I I n n s s t t a a l l l l a a t t i i o o n n S S t t a a n n d d a a r r d d s s
V
VIII
VI
RCS1148
IX
RCS1149
51