E E v v a a p p o o r r a a t t o o r r I I n n s s t t a a l l l l a a t t i i o o n n S S t t a a n n d d a a r r d d s s
Drain Hose Resistance Wire Installation Guide
I I m m p p o o r r t t a a n n t t : : The following information is provided as a guide to help ensure the proper routing of the drain hose
resistance wires. You should supplement this guide with whatever other documentation is required for your
facility.
F F i i r r e e H H a a z z a a r r d d ! !
N N e e v v e e r r b b u u n n d d l l e e e e v v a a p p o o r r a a t t o o r r d d r r a a i i n n h h o o s s e e r r e e s s i i s s t t a a n n c c e e w w i i r r e e s s t t o o g g e e t t h h e e r r a a s s t t h h e e a a m m o o u u n n t t o o f f h h e e a a t t p p r r o o d d u u c c e e d d c c o o u u l l d d r r e e s s u u l l t t i i n n
a a f f i i r r e e ! !
I I m m p p o o r r t t a a n n t t : : The following points must be followed during installation:
•
DO NOT CUT HEATER RESISTANCE WIRES!
•
DO NOT install more than one heater resistance wire into each drain tube.
•
DO NOT "ball up"or bundle heater resistance wires inside drain tubes.
•
DO NOT use band wraps to hold heater resistance wires.
•
DO NOT cover or wrap heater resistance wires.
•
DO NOT pinch the end of the heater resistance wires tight.
I I n n s s t t a a l l l l a a t t i i o o n n P P r r o o c c e e d d u u r r e e s s
1. Pull resistance wire straight out from evaporator drain tube.
2. Locate the evaporator defrost drain furthest from truck/trailer wall (i.e. in the middle of the truck/trailer), and
measure 33.00 in. (838 mm) of resistance wire from drain pan outlet ( ( D D e e t t a a i i l l I I ) ) .
3. Bend resistance wire at this point and double it over ( ( D D e e t t a a i i l l I I I I ) ) .
4. After doubling resistance wire over take excess wire and insert it back into evaporator drain tube ( ( D D e e t t a a i i l l I I I I I I ) ) .
I
50
D D A A N N G G E E R R
II
III
RCS1147
TK 56701-1-IM-EN