Advertisement
3. Unscrew these two screws to remove the worm
assembly supporting block from the. Unscrew
two aluminum standoffs.
4. Clean and re-grease the ring gear.
5. Grease the R.A. worm of a new iEQ30 Pro RA
motor assembly.
6. Place the iEQ30 Pro R.A. module onto the mount.
Insert two new gear positioning screws that come
with the package and tighten them loosely, as
shown in the following photo. You need the
special wrench to access one of the two screws.
Internal Use Only
Insert and loosely tighten other two screws on
the other side of the mount, as shown in the
following photo.
7. Double check the spacing between R.A. worm
mounting bracket and the front cover of ring gear
housing to make sure they are evenly spaced
form end to end.
8. Fasten the R.A. module by tightening these two
gear positioning screws first, as shown in the
following.
Then tighten the other two screws on the other
side of the mount.
Advertisement
