Selecting The Oven Mode; Oven Vent - Bosch HES242U Use And Care Manual

Setting the Cooking Mode
1. Touch COOKING MODE.
2. BAKE will flash in the display.
If no further setting is made within 5 seconds, control will
beep and flash. If this occurs, press START.
3. To change the cooking mode, turn knob.
4. Push START.
The selected mode will appear in the display, along with
the default temperature for that mode, which will be
blinking.
5. To select a different temperature, turn knob to the
right or left (in 5° increments) to desired temperature.
6. Touch START. If STARTis not touched, oven will
automatically turn on in 5 seconds.
7. The display alternates between the cooking mode and
preheat.
The preheated temperature is also displayed, starting at
100ºF. The actual temperature increases until set
temperature is reached, at which point the oven will
beep.
8. To change temperature during cooking, simply touch
Temperature. Turn the knob to select new
Temperature and press START.
9. Once cooking has been completed, touch OFF to
turn off oven.
Note: After the oven has been turned off, HOT appears in the
display where the cooking mode was. This is to indicate that
the oven is off but still hot. When the oven temperature drops
below 176° F, HOT is no longer seen in the display.
Oven Operation Time
The oven will automatically shut off after 12 hours (24 hours
if the time format is set for 24 hour in the SELECT FUNCTION
section).

Oven Vent

The oven vent is located below the display above the rear left
cooktop element.
It is normal to see steam escaping from the vent and
condensation may collect on the backgaurd and cooktop.
This area may become hot when the oven is in use.
Do not block the vent as it is important for air circulation.

Selecting the Oven Mode

Page 17
6: 35 6: 35 6: 35
6: 35 6: 35
380º 380º 380º 380º 380º
PM
1 1 1 1 1 0 0 0 0 0 0 0 0 0 0 B B B B B AKE AKE AKE AKE
AKE
HELPFUL TIP
To back out of a current
mode, push OFF.
Selecting OFF when not in a
setting up mode will stop
oven function.