GE CARESCAPE User Manual page 436

Printing
4. Select the printout type from the Printout list.
Note that the printing location (see step 5) for Telemetry Waveforms will only be
sent to the telemetry when starting the combination monitoring mode with a
non-admitted telemetry patient.
5. Select the location for the printout:
If you are printing to this location
Local recorder XE-50 or PRN 50-M
(connected directly to or built in the
monitor).
This selection is only available for
Telemetry Waveforms if the PRN 50-M
recorder is connected.
Remote recorder or printer (a recorder
in another monitor in the CARESCAPE
network, or a recorder or a printer
connected to a central station in the
network).
Network printer (a printer in the IX Network
or connected to an iCentral).
This is always the print location for reports.
This is not available if the printout type is
Telemetry Waveforms.
6. According to your location selection above:
a. If you selected Network: Select the print device from the Network Device list.
b. If you selected Remote: Choose the monitor or central station from the Unit
list, and then select the print device from the Remote Device list.
NOTE
NOTE
Checking the print status
You can view the assigned print locations for each type of printout and check the
printer status for each print device.
1. Select Monitor Setup > Printing.
2. Select the Devices tab > Status.
Printing waveforms
Printing waveforms for an arrhythmia alarm
NOTE
1. Select Alarm Setup from the main menu.
436
Select this option
Local
Remote
Network
You may assign one printout type to one print location only.
Changing the print location does not affect printing currently
in progress.
Automatic printing of waveforms is always initiated by an
alarm.
CARESCAPE Modular Monitors 2062971-001