System Cover - Dell PowerEdge 700 Installation And Troubleshooting Manual

NOTE: Figure 5-1 shows the system standing upright as the bezel is being removed. However, before you service components inside the system, lay
the system on its right side.
Installing the Bezel
To install the bezel, align the hooks at the bottom of the bezel, swing the top of the bezel forward toward the system, and press the bezel to the system until
it snaps into place. Using the system key, lock the bezel.

System Cover

To upgrade or troubleshoot the system, remove the system cover to gain access to internal components.
Removing the Cover
CAUTION: See your System Information Guide for complete information about safety precautions, working inside the computer, and protecting
against electrostatic discharge.
1. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the bezel. See "Removing the
3. Lay the system on its right side.
4. Loosen the thumbscrews at the front of the system. See Figure 5-2.
5. Slide the cover backward and grasp it at both ends.
6. Lift the front edge of the cover 2.5 cm (1 inch), slide the cover toward the top of the system, and then lift the cover away from the system.
Replacing the Cover
1. Ensure that all cables are connected, and fold cables out of the way.
2. Ensure that no tools or loose parts are left inside the system.
3. Fit the cover on the side of the system, and slide the cover forward.
4. Tighten the two cover thumbscrews to secure the cover. See Figure 5-2.
Figure 5-2. Removing the Cover
Bezel."